ERIKC Bosch F 00V C40 401 shim Guide bush CR F00VC40401 Common Rail nozzle valve washer Sleeve F00V C40 401

ERIKC Bosch F 00V C40 401 shim Guide bush CR F00VC40401 Common Rail nozzle valve washer Sleeve F00V C40 401

Product Picture

Injector FAQ

FAQ: What do the terms “static” and “duty cycle” mean?

ERIKC Answer:An injector in an engine turns on and off very quickly to control the amount of fuel delivered. The amount of time an injector is turned on and delivering fuel is known as the duty cycle. This is measured as a percent, so 50% duty cycle indicates that the injector is held open and held closed for an equal amount of time. When the engine needs more fuel, the time that the injector stays on (its duty cycle) increases so that more fuel can flow into the engine. If an injector stays on all the time, it is said to be static (wide open, or 100% duty cycle). Injectors should not go static in a running engine. If an injector is static in a running engine (open 100% of the time), that injector is no longer able to control fuel delivery. This could be an indication that the injector is too small for the needs of the engine. Injector duty cycle should usually not exceed 80% in a running engine at any time.

FAQ: What is an injector’s static flow rate?

ERIKC Answer:Manufacturers rate fuel injectors by the maximum amount of fuel that they can flow in a given amount of time. This measurement is taken with the injector on 100% of the time (100% duty cycle, or wide open) and with the fuel at a given pressure (usually 43.5 psi). For example, a 19 pound per hour (Lb/Hr.) injector flow 19 pounds of fuel in one hour at 100% duty cycle and 43.5 psi of fuel pressure. Injectors in imported vehicles are often rated in cubic centimeters per minute (cc/min) instead of pounds per hour. This is also done at 100% duty cycle.

common rail spare parts

common rail pressure relief valve

ERIKC Bosch F 00V C40 401 shim Guide bush CR F00VC40401 Common Rail nozzle valve washer Sleeve F00V C40 401 Images